- 1 Where should my vocals sit in the mix?
- 2 Should vocals be in the middle?
- 3 What DB should vocals be in a mix?
- 4 How do you mix vocals with a mastered beat?
- 5 How do professionals mix their vocals?
- 6 How do you EQ vocals like a pro?
- 7 How do you master tracks?
- 8 Should I mix vocals first?
- 9 What EQ frequency is vocals?
- 10 Should I mix vocals in mono or stereo?
Where should my vocals sit in the mix?
Tip #1 – Here’s a top notch trick to get your vocals to sit on top of the mix nicely. Send everything but the vocals to their own aux, and apply a very subtle compressor (only a few dB’s reduction). Side chain the lead vocals to this compressor. This will dip the track by a 2 or 3 dB’s every time the vocals come in.
Should vocals be in the middle?
Traditionally it should be mono. Although if you’re stacking vocals or using some sort of effect like izotopes vocalsynth, you can do some cool things playing with the stereo width. Traditionally your main vocal is going to be centered and not particularly wide. Backing vocals, harmonies, etc.
What DB should vocals be in a mix?
If you mix them too loudly, they will stick out. What dB should vocals be recorded at? You should record vocals at an average of -18dB for 24-bit resolution. The loudest parts of the recording should peak at -10dB and be lowest at -24dB.
How do you mix vocals with a mastered beat?
How to Mix Vocals to an Already Mastered Instrumental
- Step 1: Reduce the Output Volume of the Mastered Instrumental.
- Step 2: Set the Input Gain at the Correct Level.
- Step 3: Apply Effects/FX.
- Step 4: Mix Your Project.
- Step 5: Create the Final Master.
How do professionals mix their vocals?
In most genres, the vocals are the most important part of the mix. 10 Ways to Make Vocals Sound Modern & Professional
- Top-End Boost.
- Use a De’Esser.
- Remove Resonances.
- Control the Dynamics with Automation.
- Catch the Peaks with a Limiter.
- Use Multiband Compression.
- Enhance the Highs with Saturation.
- Use Delays Instead of Reverb.
How do you EQ vocals like a pro?
Best EQ Settings for Vocals
- Roll off the low-end starting around 90 Hz.
- Reduce the mud around 250 Hz.
- Add a high shelf around 9 kHz & a high roll off around 18 kHz.
- Add a presence boost around 5 kHz.
- Boost the core around 1 kHz to 2 kHz.
- Reduce sibilance around 5 kHz to 8 kHz.
How do you master tracks?
So without further ado, here’s the 14 Steps to Master Your Mix:
- Step 1: Optimize Your Listening Space.
- Step 2: Finish Your Mix (to Sound Mastered).
- Step 3: Check the Levels.
- Step 4: Bounce Down Your Stereo Track.
- Step 5: Take a Break (of at LEAST One Day).
- Step 6: Create a New Project and Import Your References.
Should I mix vocals first?
mix whatever you consider the most important first. I usually start with making a “bed” for the vocals from a pad, guitar, bass, kick etc and then make the lead vocals sit on top of that.
What EQ frequency is vocals?
Male vocals will tend to have their fundamental frequencies between 100–300 Hz, while the fundamental frequencies of a female vocal will usually fall between 200–400 Hz.
Should I mix vocals in mono or stereo?
If you record one vocalist, your vocals should be mono. However, if you record two vocalists or more or if you record in a room with unique acoustics, the vocals should be stereo. Moreover, recording vocals in mono makes them sound powerful, clear, and upfront.