- 1 How do you add vocal compression?
- 2 Should I compress vocals before or after recording?
- 3 What is a good compression ratio for vocals?
- 4 How do you do multiband compression on vocals?
- 5 How loud should vocals be in a mix?
- 6 How can I make my voice sound thicker?
- 7 Should I record vocals without effects?
- 8 Should I use parallel compression on vocals?
- 9 Should I use compression on vocals?
- 10 How much compression do you need for rap vocals?
How do you add vocal compression?
Dial in some heavy compression (aim for 6 dB’s of gain reduction or more). Start with an attack time of 5ms and a release of 30ms and go from there. Bring up the new aux underneath the lead vocal until it starts to increase the volume of the vocal. As soon as you notice an increase in apparent volume, stop.
Should I compress vocals before or after recording?
So perhaps the best advice is to conservatively apply the best of both worlds: use a little compression while recording — just enough to help limit the most unruly peaks and phrases and to even out the recorded signal — and then add more compression to taste during mixing.
What is a good compression ratio for vocals?
A good starting point for a rock vocal would be a 4:1 ratio with a medium-fast attack and a medium release. Then, set the threshold for around 4 to 6dB of gain reduction. Increase or decrease the attack time until you get the right level of forwardness for the mix.
How do you do multiband compression on vocals?
Once you know the range, remove the EQ and load up a multiband compressor. Bypass all of the multiband ranges until you are only targeting the problematic frequency range. Apply 2-3dB of compression using similar settings to your main compressor, with one important exception—don’t apply any makeup gain.
How loud should vocals be in a mix?
Every vocal is different and every song is different as well. But generally speaking, lead vocal should be moderately loud or the loudest element next to your drums in your mix.
How can I make my voice sound thicker?
Once you apply these ten techniques, your mixes as a whole will improve.
- Top-End Boost.
- Use a De’Esser.
- Remove Resonances.
- Control the Dynamics with Automation.
- Catch the Peaks with a Limiter.
- Use Multiband Compression.
- Enhance the Highs with Saturation.
- Use Delays Instead of Reverb.
Should I record vocals without effects?
Vocals should always be recorded dry. Meaning that there are no time based effects such as reverb and delay on the track when you record.
Should I use parallel compression on vocals?
Using parallel compression can be an effective way to give your vocals a professional edge but it’s a difficult technique to master. Use gates, EQ and de essers to remove content you don’t want to be harshly compressed.
Should I use compression on vocals?
Lead vocals Some recording engineers think compression is a must for vocals. It evens out the often-erratic levels that a singer can produce and tames transients that can cause digital distortion. You can use compression on vocals to just even out the performance and to create an effect.
How much compression do you need for rap vocals?
Generally, in normal vocals 2:1 to 3:1 ratio is good to compress the upper dynamics. But when the vocal is aggressive you need to compress more. So you have to increase the ratio up to 7:1.