- 1 Should vocals be recorded in mono or stereo?
- 2 Should you record vocals separate?
- 3 Do mics need to be matched?
- 4 Do matched pairs matter?
- 5 Do rappers double their vocals?
- 6 Should vocals be panned?
- 7 Should vocals be louder than the beat?
- 8 What program is best for recording vocals?
- 9 What dB should vocals be in a mix?
- 10 Do you need 2 mics for stereo?
- 11 How important is a matched pair?
- 12 Does RAM have to be in matched pairs?
- 13 Does DDR4 have to be installed in pairs?
- 14 What is a matched pair in audio?
Should vocals be recorded in mono or stereo?
If you are recording the vocals of one singer in a booth, then you should record in mono. However, if you are recording vocals of multiple singers and instruments, you should record in stereo. The terms mono and stereo are quite common in the sound recording industry.
Should you record vocals separate?
Yes, in terms of hi-fidelity recording, you are better off recording your main instrument separately, and then your vocal. But often you’ll lose so much atmosphere and vitality in doing that. Comes down to what you want to get out of your recordings, ultimately.
Do mics need to be matched?
Matching is only needed when the tolerances are so wide in the first place that there are noticeable differences from one unit to another, which just isn’t the case with most modern designs.
Do matched pairs matter?
Even small differences in the polar pattern and frequency response of the two mics in an X-Y pair will have an adverse effects on stereo image. Using a matched pair — these are Rode NT5s — is recommended.
Do rappers double their vocals?
Rappers and singers have traditionally recorded vocal doubles (informally called “vocal dubs”) on the ending phrases every bar or half a bar..
Should vocals be panned?
The best way to give your mix a solid core is to keep lower frequency sounds in the center. That means kicks, basses and anything else below the 120hz range. If your track has lead vocals pan them center as well. But as a general rule lead vocals should always be panned center.
Should vocals be louder than the beat?
How loud should vocals be compared to instrumental. Vocals, especially the lead vocal should be louder than musical elements but a tad bit behind the drum transients in my opinion. But if you have an instrumental that has already been mastered and hyper-compressed which is often the case.
What program is best for recording vocals?
11 best voice recording software options
- Audio Hijack.
- Sony ACID Xpress.
What dB should vocals be in a mix?
If you mix them too loudly, they will stick out. What dB should vocals be recorded at? You should record vocals at an average of -18dB for 24-bit resolution. The loudest parts of the recording should peak at -10dB and be lowest at -24dB.
Do you need 2 mics for stereo?
You need 2 mics paired together that record using Stereo techniques recording in a different frequency, distances, or time.
How important is a matched pair?
Many factors are involved in producing matched pairs of microphones, and they’re highly recommended for stereo recording. This polar‑pattern precision is actually where the biggest differences occur between mics, and it is also what determines stereo imaging precision when you use the mics as a coincident pair.
Does RAM have to be in matched pairs?
2 Answers. Memory doesn’t have to be installed in pairs, but it is recommended in pretty much any modern motherboard as this is what enables Dual Channel mode which can (under some circumstances) dramatically increase performance.
Does DDR4 have to be installed in pairs?
Yes DDR4 must be installed in pairs.
What is a matched pair in audio?
A “matched pair” is a set of two microphones that sound the same. Those specs are just a technical way to express that the two mics sound essentially identical. (Beware of companies that only match for sensitivity, or limit the frequency range matching to a few octaves in the middle of the audible range.)