Readers ask: When Recording Vocals Mono Or Stereo?

Is it better to record in mono or stereo?

We need both mono and stereo in both the recording and mixing stages. Mono recording is perfect for vocals and can work on other instruments. Stereo recording works well on acoustic guitar and even drums. Mono mixing helps you end up with a track that sounds good everywhere.

Should vocals be mixed in mono or stereo?

Songs with vocals are mixed so that the priority focus is on the lead singer. Therefore, most producers and engineers opt for mixing the dry lead vocal signal in mono, while mixing the vocal effects, such as reverb and delays in stereo.

Should you put vocals in mono?

The lead vocal should be in mono and central in the mix but the BVs can have as much width as you like. Keep it balanced, pan as many left as you do right.

Should you stereo spread vocals?

Separate stereo – You might be tempted to put a doubler or a stereo spread on the main vocal track. Don’ t. Send your main vocal to a separate bus so you can keep the punchiness of the main vocal track with some extra stereo spread from the bus underneath.

You might be interested:  Question: How To Get Vocals To Sit In The Mix?

Are microphones mono or stereo?

Do microphones output mono or stereo signals? Microphones convert sound waves to audio signals via mic capsules. Most mics have one capsule that outputs one signal, making them mono devices. Some mics have multiple capsules and output multiple mono signals (which could be mixed in stereo).

Are guitars mono or stereo?

Generally, electric guitars are recorded in mono and may be double-tracked with panning. On the other hand, acoustic (steel string) and classical (nylon string) guitars are either recorded in mono or using stereo micing techniques depending on the musical context and goals.

Is stereo louder than mono?

Is stereo louder than mono? Stereo isn’t louder than mono. However, stereo may sound louder since it sends two different channels to the speakers, and creates a simulation of space and width. But, if you compare them both on even speakers with the same volume settings, they should both be at an equal dB level.

How loud should my vocals be in a mix?

Every vocal is different and every song is different as well. But generally speaking, lead vocal should be moderately loud or the loudest element next to your drums in your mix.

What dB should vocals be in a mix?

If you mix them too loudly, they will stick out. What dB should vocals be recorded at? You should record vocals at an average of -18dB for 24-bit resolution. The loudest parts of the recording should peak at -10dB and be lowest at -24dB.

How do you balance vocals in a mix?

Tip #1 – Here’s a top notch trick to get your vocals to sit on top of the mix nicely. Send everything but the vocals to their own aux, and apply a very subtle compressor (only a few dB’s reduction). Side chain the lead vocals to this compressor. This will dip the track by a 2 or 3 dB’s every time the vocals come in.

You might be interested:  How To Sing Grunge Vocals?

Is Bass a mono or stereo?

As a general rule of thumb, it’s considered common practice to sum anything below 200hz to mono. This means your bass, sub-bass, and kick drum will almost always be summed to mono.

What’s the difference between mono and stereo?

Mono sound is when only one channel is used to convert a signal to a sound. Stereo sound is when multiple channels are used to convert multiple signals to sounds.

Leave a Reply

Your email address will not be published. Required fields are marked *