- 1 How do you adjust vocal compressions?
- 2 How do I set my live vocal compressor?
- 3 How can I make my vocals sound better?
- 4 Should you compress live vocals?
- 5 How loud should vocals be in a mix?
- 6 How do you balance vocals in a mix?
- 7 Why do my vocals sound amatuer?
- 8 How do I set mastering limiter?
- 9 How do I compress vocals like a pro?
- 10 Should you compress or EQ first?
How do you adjust vocal compressions?
A good starting point for a rock vocal would be a 4:1 ratio with a medium-fast attack and a medium release. Then, set the threshold for around 4 to 6dB of gain reduction. Increase or decrease the attack time until you get the right level of forwardness for the mix.
How do I set my live vocal compressor?
While listening to your entire mix (do not solo the vocal), pull down the threshold until the compressor starts compressing. Add makeup gain as needed so the vocal doesn’t drop in volume. Adjust the threshold, ratio, and makeup gain until you can hear every word of the performance clearly.
How can I make my vocals sound better?
10 Ways to Make Vocals Sound Modern & Professional
- Top-End Boost.
- Use a De’Esser.
- Remove Resonances.
- Control the Dynamics with Automation.
- Catch the Peaks with a Limiter.
- Use Multiband Compression.
- Enhance the Highs with Saturation.
- Use Delays Instead of Reverb.
Should you compress live vocals?
Live sound is largely correcting problems with subtractive EQ. Sure, it’s fun to roll off some of the top-end on your hall reverb, but don’t let that distract you from the things that actually need attention. Compression should be used sparingly. The lead vocals should be the center of your attention.
How loud should vocals be in a mix?
Every vocal is different and every song is different as well. But generally speaking, lead vocal should be moderately loud or the loudest element next to your drums in your mix.
How do you balance vocals in a mix?
Tip #1 – Here’s a top notch trick to get your vocals to sit on top of the mix nicely. Send everything but the vocals to their own aux, and apply a very subtle compressor (only a few dB’s reduction). Side chain the lead vocals to this compressor. This will dip the track by a 2 or 3 dB’s every time the vocals come in.
Why do my vocals sound amatuer?
Another reason you may hear vocals sticking out so much is if they were recorded over a ‘beat’ or a pre-made composition. It’s hard to make room for/blend a vocal into an instrumental track that’s already been produced since you have a lot less control over individual instruments.
How do I set mastering limiter?
To set a limiter, first identify the loudest section of a song. This is the part where the limiter will react most drastically. It is best to check for distortion in this area. Once you’ve found the loudest part of the song, insert a limiter of your choice on your master bus and listen to your recording.
How do I compress vocals like a pro?
This is how to compress vocals using a lighter, more musical approach:
- First of all, load up a compressor.
- Next, lower the threshold and raise the ratio to extreme settings.
- Start with a medium attack time around 15ms and adjust to taste.
- Dial in a medium release time of 40ms and adjust from there.
Should you compress or EQ first?
Each position, EQ pre (before) or EQ post (after) compression produces a distinctly different sound, a different tonal quality, and coloration. As a rule, using EQ in front of your compressor produces a warmer, rounder tone, while using EQ after your compressor produces a cleaner, clearer sound.