Readers ask: How To Mix Vocals The Pro Way?

How do professionals mix their vocals?

In most genres, the vocals are the most important part of the mix. 10 Ways to Make Vocals Sound Modern & Professional

  1. Top-End Boost.
  2. Use a De’Esser.
  3. Remove Resonances.
  4. Control the Dynamics with Automation.
  5. Catch the Peaks with a Limiter.
  6. Use Multiband Compression.
  7. Enhance the Highs with Saturation.
  8. Use Delays Instead of Reverb.

How do you EQ vocals like a pro?

Best EQ Settings for Vocals

  1. Roll off the low-end starting around 90 Hz.
  2. Reduce the mud around 250 Hz.
  3. Add a high shelf around 9 kHz & a high roll off around 18 kHz.
  4. Add a presence boost around 5 kHz.
  5. Boost the core around 1 kHz to 2 kHz.
  6. Reduce sibilance around 5 kHz to 8 kHz.

How do you mix your vocals step by step?

VOCAL MIXING CHAINS STEPS

  1. STEP 1 – CORRECTIVE EQ. Remove annoying frequencies.
  2. STEP 2 – DYNAMIC COMPRESSION. tame unruly peaks for more consistent vocal.
  3. STEP 3 – TONAL SHAPING EQ. bring out presence, midrange power, and air.
  4. STEP 4 – DE-ESSER.
  5. STEP 5 TONAL DENSITY COMPRESSION.
  6. STEP 6 – VOLUME.
  7. STEP 7 – SATURATION.

What order should you mix vocals?

In this article, you’ll learn the secrets to creating radio-ready vocals.

  1. Step 1: Get A Great Recording.
  2. Step 2: Editing. Apply Subtle Pitch Correction.
  3. Step 3: Gain Automation (The Secret Sauce)
  4. Step 4: Prepare the Session.
  5. Step 7: Gain Staging.
  6. Step 5: Surgical EQ.
  7. Step 6: De-Essing (Optional)
  8. Step 7: The First Compressor.
You might be interested:  FAQ: Who Did Tom Cruise's Vocals In Rock Of Ages?

What dB should my vocals be at?

What dB should vocals be recorded at? You should record vocals at an average of -18dB for 24-bit resolution. The loudest parts of the recording should peak at -10dB and be lowest at -24dB. This is to keep an even balance on the level of the vocals without distortion.

Why do my vocals sound amatuer?

Another reason you may hear vocals sticking out so much is if they were recorded over a ‘beat’ or a pre-made composition. It’s hard to make room for/blend a vocal into an instrumental track that’s already been produced since you have a lot less control over individual instruments.

Is a condenser mic better for vocals?

Condenser microphones are best used to capture vocals and high frequencies. They are also the preferred type of microphone for most studio applications. Because of the thin diaphragm and increased sensitivity, condenser mics are often used to pick up delicate sounds. They also need a power source.

How do you make vocals in punchy?

A fast attack (5ms) will make your vocals sound thick and heavy. A slow attack (30ms) will make your vocals sound punchy and aggressive. Dial in a medium release time of 40ms and adjust from there. Try to get the compressor pumping in time with the music.

Leave a Reply

Your email address will not be published. Required fields are marked *