Is Cubase 5 good for recording vocals?
One of the many areas it really shines in is vocal recording. Straight out of the box Cubase is more than capable of recording and processing vocals for voice over, music and podcast projects.
How do you mix your vocals step by step?
VOCAL MIXING CHAINS STEPS
- STEP 1 – CORRECTIVE EQ. Remove annoying frequencies.
- STEP 2 – DYNAMIC COMPRESSION. tame unruly peaks for more consistent vocal.
- STEP 3 – TONAL SHAPING EQ. bring out presence, midrange power, and air.
- STEP 4 – DE-ESSER.
- STEP 5 TONAL DENSITY COMPRESSION.
- STEP 6 – VOLUME.
- STEP 7 – SATURATION.
How do you process vocals for an amazing professional sound?
Once you apply these ten techniques, your mixes as a whole will improve.
- Top-End Boost.
- Use a De’Esser.
- Remove Resonances.
- Control the Dynamics with Automation.
- Catch the Peaks with a Limiter.
- Use Multiband Compression.
- Enhance the Highs with Saturation.
- Use Delays Instead of Reverb.
How do you process sound?
Sound waves enter the outer ear and travel through a narrow passageway called the ear canal, which leads to the eardrum. The eardrum vibrates from the incoming sound waves and sends these vibrations to three tiny bones in the middle ear.
Can you record vocals on Cubase Elements?
Mute the existing vocal take in Cubase and create a new track beneath it. Initiate playback and record a rough take of the whole song vocally, adjust your preamp output volume and the input of your audio interface to reach a comfortable level.
How do you balance vocals in a mix?
Tip #1 – Here’s a top notch trick to get your vocals to sit on top of the mix nicely. Send everything but the vocals to their own aux, and apply a very subtle compressor (only a few dB’s reduction). Side chain the lead vocals to this compressor. This will dip the track by a 2 or 3 dB’s every time the vocals come in.
What dB should vocals be in a mix?
If you mix them too loudly, they will stick out. What dB should vocals be recorded at? You should record vocals at an average of -18dB for 24-bit resolution. The loudest parts of the recording should peak at -10dB and be lowest at -24dB.