- 1 How do I make my vocals sound more mixed?
- 2 How loud should vocals be in a rock mix?
- 3 How do you get distorted vocals?
- 4 Why do my vocals sound bad?
- 5 What frequency do vocals sit?
- 6 Should Beat be louder than vocals?
- 7 Should Kick be louder than snare?
- 8 What dB should your 808 be?
- 9 How can I make my voice gritty?
How do I make my vocals sound more mixed?
Once you apply these ten techniques, your mixes as a whole will improve.
- Top-End Boost.
- Use a De’Esser.
- Remove Resonances.
- Control the Dynamics with Automation.
- Catch the Peaks with a Limiter.
- Use Multiband Compression.
- Enhance the Highs with Saturation.
- Use Delays Instead of Reverb.
How loud should vocals be in a rock mix?
If you mix them too loudly, they will stick out. What dB should vocals be recorded at? You should record vocals at an average of -18dB for 24-bit resolution. The loudest parts of the recording should peak at -10dB and be lowest at -24dB.
How do you get distorted vocals?
Vocal distortion Add an overdrive effect to a bus, roll off some of the top and bottom, then blend with the dry vocal to taste. It’s also often worth distorting the vocal before it hits your effects chain, for a fuller, more authentic tone.
Why do my vocals sound bad?
If your vocals are recorded in a bad room, it’s extremely obvious by the end of the mix. The room that an instrument is recorded in always changes the tone. This is ESPECIALLY true for vocals. Room reflections can also cause compression and pitch correction to sound unnatural.
What frequency do vocals sit?
Male vocals will tend to have their fundamental frequencies between 100–300 Hz, while the fundamental frequencies of a female vocal will usually fall between 200–400 Hz.
Should Beat be louder than vocals?
Should Vocals be Louder than the beat? No and Yes! Well it depends on the genre and style you are mixing or what the song calls for. What you don’t want is a vocal poking out like a sore thumb in your song.
Should Kick be louder than snare?
The snare is the foundation of the backbeat, and typically one of the loudest elements in the mix. Next, bring the kick fader up until it sounds almost as loud as the snare. It should be loud enough that the low frequencies are rich and powerful, but not so loud that it masks the bottom-end of the snare drum.
What dB should your 808 be?
Just make it loud in the context of the mix. Start with all your faders down. Bring up the 808 so it’s at a reasonable level in your DAW (probably somewhere around -18 dBFS ). Then, bring in all of the other instruments around it.
How can I make my voice gritty?
Many singers think grit comes from tightening their vocal cords or tensing up to get that aggressive edge, but doing so actually does more harm than good. Grit should come from pushing more air through your vocal cords with varying intensity. Great, gritty vocals come from confidence and power, not strain.