Readers ask: How To Know When To Add Background Vocals?

Where should you pan background vocals?

If you have several background tracks, you’ll want to pan them away from the center. This will create space for your vocal to live in. How much you pan your BGVs is up to you.

How much quieter should background vocals be?

Background vocals should sit somewhere underneath the leads in terms of volume. There’s no one-mix-fits-all dB amount to go by, but you should definitely be thinking in terms of quieter backgrounds and louder leads.

How do you put a background on your voice?

The Top Seven Ways for Blending Backing Vocals

  1. Less volume. Most of the time, the backing vocalists are supporting the lead singer.
  2. Roll off some of their high frequencies.
  3. Back off the lows.
  4. Separate and blend with reverb.
  5. Compress them.
  6. Actively mix them.
  7. Blend the vocalists together.

Should background vocals be mono or stereo?

If you record one vocalist, your vocals should be mono. However, if you record two vocalists or more or if you record in a room with unique acoustics, the vocals should be stereo. Moreover, recording vocals in mono makes them sound powerful, clear, and upfront.

You might be interested:  Question: How To Rip Vocals Off A Trac?

Where do you put vocals in a mix?

Tip #1 – Here’s a top notch trick to get your vocals to sit on top of the mix nicely. Send everything but the vocals to their own aux, and apply a very subtle compressor (only a few dB’s reduction). Side chain the lead vocals to this compressor. This will dip the track by a 2 or 3 dB’s every time the vocals come in.

Should backing vocals be panned?

It depends on how you whant the backing vocals to sound. I suggest you try hard panning two of them and have the other two halfway to each side. This way you get the width but it will sound more solid and cohesive across the stereo image.

Should I pan vocal harmonies?

Try and think of background stacks or harmonies as one. They are going to accompany the lead vocal/melody and therefore don’t necessarily have to be easily heard on their own. Just pan them hard left and hard right and focus more on the blend (to sound like a chord) and also the contrast between the lead vocals.

Should you pan vocals?

The best way to give your mix a solid core is to keep lower frequency sounds in the center. That means kicks, basses and anything else below the 120hz range. If your track has lead vocals pan them center as well. But as a general rule lead vocals should always be panned center.

How do you blend vocal harmonies?

First, pan your lead vocal down the middle, then, like we talked about with doubling, pan your doubles hard left and hard right. The same goes for doubles of your harmonies, if you have them. Then you can play with pads, textures and chops once you’ve found the proper balance with your vocal tracks.

You might be interested:  FAQ: How To Mix Metal Vocals?

Is stereo better than mono?

Stereo isn’t necessarily better than mono. Stereo sounds wider, more detailed, and more realistic. However, depending on where it’s played, stereo sometimes creates phase cancellation issues that make it sound hollow, empty, and weird. Stereo is recommended when your listening environment is normal.

Should lead vocals be in mono?

The lead vocal should be in mono and central in the mix but the BVs can have as much width as you like. Keep it balanced, pan as many left as you do right.

Leave a Reply

Your email address will not be published. Required fields are marked *