Quick Answer: How To Layer Beats With Vocals?

Can you mix vocals with beats?

You can do both depending on what kind of release you plan on doing. If you are just putting out a tape to grab exposure then placing vocals over a mastered beat is fine. If you’re planning to release a debut album then I would suggest mixing the beat with the vocals.

How do you layer your vocals?

First, pan your lead vocal down the middle, then, like we talked about with doubling, pan your doubles hard left and hard right. The same goes for doubles of your harmonies, if you have them. Then you can play with pads, textures and chops once you’ve found the proper balance with your vocal tracks.

Should vocals be higher than beat?

Should Vocals be Louder than the beat? No and Yes! Well it depends on the genre and style you are mixing or what the song calls for. What you don’t want is a vocal poking out like a sore thumb in your song.

Should I layer my vocals?

Loosely layered vocals will cause you to lose the intimacy you are trying to create. There is an effect you should be aware of though when layering these parts. If your performance is so tight then your vocals will start to sound phasey. Almost canceling out the center image.

You might be interested:  FAQ: How To Sidechain Vocals Ableton?

Should I layer rap vocals?

If you’re recording a chorus (for rap or a singing style song),your audio engineer can use the vocal double to pan them to the sides to get a more stereo sound. For choruses, in general, I’d recommend recording additional vocal layers of the main vocal to be panned to the left and right side.

What is vocal stacking?

What does it mean to “stack” a vocal? Stacking vocals in a very general sense just means having multiple vocal tracks in your session. When you’ve got two vocals playing back at the same time, you add complexity and density to your mix.

What dB should my vocals be at?

What dB should vocals be recorded at? You should record vocals at an average of -18dB for 24-bit resolution. The loudest parts of the recording should peak at -10dB and be lowest at -24dB. This is to keep an even balance on the level of the vocals without distortion.

How do I make my vocals closer?

Once you apply these ten techniques, your mixes as a whole will improve.

  1. Top-End Boost.
  2. Use a De’Esser.
  3. Remove Resonances.
  4. Control the Dynamics with Automation.
  5. Catch the Peaks with a Limiter.
  6. Use Multiband Compression.
  7. Enhance the Highs with Saturation.
  8. Use Delays Instead of Reverb.

What frequency do vocals sit?

Male vocals will tend to have their fundamental frequencies between 100–300 Hz, while the fundamental frequencies of a female vocal will usually fall between 200–400 Hz.

Should Kick be louder than snare?

The snare is the foundation of the backbeat, and typically one of the loudest elements in the mix. Next, bring the kick fader up until it sounds almost as loud as the snare. It should be loud enough that the low frequencies are rich and powerful, but not so loud that it masks the bottom-end of the snare drum.

You might be interested:  FAQ: How Do I Turn Down The Volume Of Instrumental I'm Recording Vocals Over In Fl Studio 12?

What dB should my mix be before mastering?

I recommend mixing at -23 dB LUFS, or having your peaks be between -18dB and -3dB. This will allow the mastering engineer the opportunity to process your song, without having to resort to turning it down.

Should vocals be mono or stereo?

Should you record vocals in mono or in stereo? If you are recording the vocals of one singer in a booth, then you should record in mono. However, if you are recording vocals of multiple singers and instruments, you should record in stereo. The terms mono and stereo are quite common in the sound recording industry.

Leave a Reply

Your email address will not be published. Required fields are marked *