Quick Answer: Do Vocals Need To Be In Mono When Producing Music?

Should vocals be stereo or mono?

Should you record vocals in mono or in stereo? If you are recording the vocals of one singer in a booth, then you should record in mono. However, if you are recording vocals of multiple singers and instruments, you should record in stereo. The terms mono and stereo are quite common in the sound recording industry.

Should you stereo spread vocals?

Separate stereo – You might be tempted to put a doubler or a stereo spread on the main vocal track. Don’ t. Send your main vocal to a separate bus so you can keep the punchiness of the main vocal track with some extra stereo spread from the bus underneath.

Should vocals be in the middle?

Traditionally it should be mono. Although if you’re stacking vocals or using some sort of effect like izotopes vocalsynth, you can do some cool things playing with the stereo width. Traditionally your main vocal is going to be centered and not particularly wide. Backing vocals, harmonies, etc.

You might be interested:  Quick Answer: Who Did Vocals For Chicago?

What dB should vocals be at?

What dB should vocals be recorded at? You should record vocals at an average of -18dB for 24-bit resolution. The loudest parts of the recording should peak at -10dB and be lowest at -24dB. This is to keep an even balance on the level of the vocals without distortion.

What is a good EQ setting for vocals?

Best EQ Settings for Vocals

  • Roll off the low-end starting around 90 Hz.
  • Reduce the mud around 250 Hz.
  • Add a high shelf around 9 kHz & a high roll off around 18 kHz.
  • Add a presence boost around 5 kHz.
  • Boost the core around 1 kHz to 2 kHz.
  • Reduce sibilance around 5 kHz to 8 kHz.

Should vocals be louder than the beat?

How loud should vocals be compared to instrumental. Vocals, especially the lead vocal should be louder than musical elements but a tad bit behind the drum transients in my opinion. But if you have an instrumental that has already been mastered and hyper-compressed which is often the case.

How do I widen my mono vocals?

If you want to widen a mono vocal, take advantage of the Haas Effect and use a stereo delay with different times on the left and right channel. Changing the pitch of one channel by just a few cents will enhance the stereo illusion.

Is Bass a mono or stereo?

As a general rule of thumb, it’s considered common practice to sum anything below 200hz to mono. This means your bass, sub-bass, and kick drum will almost always be summed to mono.

How do you balance vocals in a mix?

Tip #1 – Here’s a top notch trick to get your vocals to sit on top of the mix nicely. Send everything but the vocals to their own aux, and apply a very subtle compressor (only a few dB’s reduction). Side chain the lead vocals to this compressor. This will dip the track by a 2 or 3 dB’s every time the vocals come in.

You might be interested:  Often asked: What Is The Best Car Amp For Vocals?

What EQ frequency is vocals?

Male vocals will tend to have their fundamental frequencies between 100–300 Hz, while the fundamental frequencies of a female vocal will usually fall between 200–400 Hz.

Should Kick be louder than snare?

The snare is the foundation of the backbeat, and typically one of the loudest elements in the mix. Next, bring the kick fader up until it sounds almost as loud as the snare. It should be loud enough that the low frequencies are rich and powerful, but not so loud that it masks the bottom-end of the snare drum.

What dB should my mix be before mastering?

I recommend mixing at -23 dB LUFS, or having your peaks be between -18dB and -3dB. This will allow the mastering engineer the opportunity to process your song, without having to resort to turning it down.

What level should background music be?

There is no target audio level for background music as this number will vary, however, to ensure your background music does not impede on the clarity of speech or narration for those with hearing problems, most experts agree that background music should be between -18dBs and -20dBs lower than the main dialogue,

Leave a Reply

Your email address will not be published. Required fields are marked *