Question: Why Did My Vocals Change Length In Logic?

How do I fix vocal clipping in logic?

On tracks you’ve already recorded, you can correct clipping by adding compression or limiter plugins.

  1. Adjust the gain level on your audio interface or preamp to reduce the overall signal level coming into Logic.
  2. Open your Logic project and adjust the volume on the track or bus that’s clipping.

How do I stop logic from changing tempo of audio files?

So just to be clear:

  1. Lock the SMPTE position on the Apple Loop.
  2. Uncheck Follow Tempo.
  3. Change the project tempo.

How do you normalize vocals in logic?

Choose Functions > Normalize from the Audio File Editor menu bar (or press Control-N). Logic Pro locates the point with the highest volume in the selected area, and determines how far it is from the maximum possible level. The level of the selected area is then raised by this amount.

Why is logic clipping?

Signal clipping occurs when a signal that is too loud is fed through the output channel strip, thereby exceeding the limit of what can be accurately reproduced, resulting in distorted sound.

Why are my vocals clipping?

When recording vocals, audio clipping can occur when you push your audio signal past what your recording device can handle. This can happen if your microphone is turned up too high for the vocal you’re recording, and it ends up adding unwanted distortion to your audio.

You might be interested:  What Are The Best Plugins For Vocals In Pro Tools?

What is smart tempo?

With Smart Tempo you can record a performance without the metronome and have Logic Pro adapt the project tempo to match the tempo of the recording, or keep the project tempo and flex the recording to match it.

Should I normalize my vocals?

It’s totally ok as long as it sounds good. You could normalize all tracks to (for example) -5, so you have a “peak-leveled” mix and start from there. Lower the volume of the beat before recording, like -10db. Then level your vocals around -18 db.

Should I normalize when bouncing in logic?

When it’s selected, Logic calculates the maximum possible volume for the bounce without exceeding 0 dBFS, and writes a resulting audio file with the optimum level for whatever format you are bouncing to. If your peak levels are right at 0 dBFS, then the Normalize function will have no effect.

When should you normalize audio?

Audio should be normalized for two reasons: 1. to get the maximum volume, and 2. for matching volumes of different songs or program segments. Peak normalization to 0 dBFS is a bad idea for any components to be used in a multi-track recording. As soon as extra processing or play tracks are added, the audio may overload.

How do I stretch an audio file?

You can stretch the time of an audio clip on the Timeline by holding [Shift] then dragging the handles on the selected clip.

Leave a Reply

Your email address will not be published. Required fields are marked *