Question: Learn How To Mix Vocals In Protools?

How do you EQ vocals like a pro?

Best EQ Settings for Vocals

  1. Roll off the low-end starting around 90 Hz.
  2. Reduce the mud around 250 Hz.
  3. Add a high shelf around 9 kHz & a high roll off around 18 kHz.
  4. Add a presence boost around 5 kHz.
  5. Boost the core around 1 kHz to 2 kHz.
  6. Reduce sibilance around 5 kHz to 8 kHz.

What dB should my vocals be at?

What dB should vocals be recorded at? You should record vocals at an average of -18dB for 24-bit resolution. The loudest parts of the recording should peak at -10dB and be lowest at -24dB. This is to keep an even balance on the level of the vocals without distortion.

How do professionals mix their vocals?

In most genres, the vocals are the most important part of the mix. 10 Ways to Make Vocals Sound Modern & Professional

  1. Top-End Boost.
  2. Use a De’Esser.
  3. Remove Resonances.
  4. Control the Dynamics with Automation.
  5. Catch the Peaks with a Limiter.
  6. Use Multiband Compression.
  7. Enhance the Highs with Saturation.
  8. Use Delays Instead of Reverb.

How do you balance vocals in a mix?

Tip #1 – Here’s a top notch trick to get your vocals to sit on top of the mix nicely. Send everything but the vocals to their own aux, and apply a very subtle compressor (only a few dB’s reduction). Side chain the lead vocals to this compressor. This will dip the track by a 2 or 3 dB’s every time the vocals come in.

You might be interested:  Often asked: What Kind Of Microphone Is Best For Recording Vocals?

Is Pro Tools better for vocals?

When it comes to the best designed interface for recording vocals, Pro Tools definitely stands out. I have used most major DAWs extensively, including FL Studio, Ableton, Pro Tools, Logic, Reaper, the list goes on… None of these DAWs have the speed and fluidity of Pro Tools when it comes to recording vocals.

How do you add warmth to vocals?

Use Parallel Processing Instead of adding all the processing on the track itself, experiment with parallel processing. I like a good LA2A in parallel on vocals, sometimes with an analog-style EQ that’s boosted in the low-mids. Added underneath, it can give your vocals all the warmth you need.

Is Pro Tools always recording?

Remember that when you are using Quick Punch, Pro Tools is actually in record all the time you are playing, and although it displays separate Regions for each patch, in fact one complete file is being created for each pass.

How can you change your voice?

Be your own vocal coach

  1. First, make a recording of your voice. Your voice may sound different to you than it does to everyone else.
  2. Read up on vocal training.
  3. Relax your voice using vocal exercises.
  4. Practice throwing your voice.
  5. Try emulating a voice you like.

What DB should my mix be before mastering?

I recommend mixing at -23 dB LUFS, or having your peaks be between -18dB and -3dB. This will allow the mastering engineer the opportunity to process your song, without having to resort to turning it down.

Should vocals be panned?

The best way to give your mix a solid core is to keep lower frequency sounds in the center. That means kicks, basses and anything else below the 120hz range. If your track has lead vocals pan them center as well. But as a general rule lead vocals should always be panned center.

You might be interested:  Who Sang Backup Vocals On You're So Vain?

Do rappers double their vocals?

Rappers and singers have traditionally recorded vocal doubles (informally called “vocal dubs”) on the ending phrases every bar or half a bar..

Leave a Reply

Your email address will not be published. Required fields are marked *