Question: How To Get Your Vocals To Sit In The Mix In Logic Pro 10 With Idol Top?

How do I get my singing voice to sit together?

9 Tips on How to Make Vocals Sit in The Mix

  1. Bring Up Fader. Why It Works – It brings up the vocal.
  2. Ride The Fader.
  3. Compress The Vocal.
  4. Compress The Mix.
  5. Limit The Mix.
  6. Boost Presence or Projection Frequencies.
  7. Boost Presence on Entire Mix.
  8. Reduce Reverb While Adding Delay.

How do you make vocals sit in the logic?

Tip #1 – Here’s a top notch trick to get your vocals to sit on top of the mix nicely. Send everything but the vocals to their own aux, and apply a very subtle compressor (only a few dB’s reduction). Side chain the lead vocals to this compressor. This will dip the track by a 2 or 3 dB’s every time the vocals come in.

How do I make my vocals sound more mixed?

Once you apply these ten techniques, your mixes as a whole will improve.

  1. Top-End Boost.
  2. Use a De’Esser.
  3. Remove Resonances.
  4. Control the Dynamics with Automation.
  5. Catch the Peaks with a Limiter.
  6. Use Multiband Compression.
  7. Enhance the Highs with Saturation.
  8. Use Delays Instead of Reverb.

What frequency do vocals sit?

Male vocals will tend to have their fundamental frequencies between 100–300 Hz, while the fundamental frequencies of a female vocal will usually fall between 200–400 Hz.

You might be interested:  FAQ: How Do You Remove The Vocals From A Song Using Mixcraft?

What dB should vocals be in a mix?

If you mix them too loudly, they will stick out. What dB should vocals be recorded at? You should record vocals at an average of -18dB for 24-bit resolution. The loudest parts of the recording should peak at -10dB and be lowest at -24dB.

Should vocals be in the middle?

Traditionally it should be mono. Although if you’re stacking vocals or using some sort of effect like izotopes vocalsynth, you can do some cool things playing with the stereo width. Traditionally your main vocal is going to be centered and not particularly wide. Backing vocals, harmonies, etc.

How do you EQ vocals like a pro?

Best EQ Settings for Vocals

  1. Roll off the low-end starting around 90 Hz.
  2. Reduce the mud around 250 Hz.
  3. Add a high shelf around 9 kHz & a high roll off around 18 kHz.
  4. Add a presence boost around 5 kHz.
  5. Boost the core around 1 kHz to 2 kHz.
  6. Reduce sibilance around 5 kHz to 8 kHz.

Should I mix vocals in mono or stereo?

If you record one vocalist, your vocals should be mono. However, if you record two vocalists or more or if you record in a room with unique acoustics, the vocals should be stereo. Moreover, recording vocals in mono makes them sound powerful, clear, and upfront.

Why do my vocals sound bad?

If your vocals are recorded in a bad room, it’s extremely obvious by the end of the mix. The room that an instrument is recorded in always changes the tone. This is ESPECIALLY true for vocals. Room reflections can also cause compression and pitch correction to sound unnatural.

You might be interested:  Songs On Which John Oates Sang Lead Vocals?

What vocal effects do singers use?

The options available for vocal effects are broad. They include reverb, delay, choir, distortion, compression, gain automation, de-essing, EQ, pitch shift, and echo.

Leave a Reply

Your email address will not be published. Required fields are marked *