Often asked: Where To Sit Your Vocals In The Mix?

How loud should my vocals be in a mix?

Every vocal is different and every song is different as well. But generally speaking, lead vocal should be moderately loud or the loudest element next to your drums in your mix.

What frequency do vocals sit?

Male vocals will tend to have their fundamental frequencies between 100–300 Hz, while the fundamental frequencies of a female vocal will usually fall between 200–400 Hz.

How do professionals mix their vocals?

In most genres, the vocals are the most important part of the mix. 10 Ways to Make Vocals Sound Modern & Professional

  1. Top-End Boost.
  2. Use a De’Esser.
  3. Remove Resonances.
  4. Control the Dynamics with Automation.
  5. Catch the Peaks with a Limiter.
  6. Use Multiband Compression.
  7. Enhance the Highs with Saturation.
  8. Use Delays Instead of Reverb.

Why do my vocals sound muffled?

When recorded vocals sound muffled, it’s usually because there is too much energy in the lower frequencies. For a really good quick lesson on what a frequency is, see our post: Good Equalization and Frequency Basics.

Are my vocals too loud in mix?

If you find that the vocals suddenly go from sounding too low in the mix to too loud, then you need to apply more dynamic processing. Vocals with wildly uncontrolled dynamics are a hallmark sign of an amateur mix engineer.

You might be interested:  How To Use Snowball Microphone To Record Vocals?

Should Kick be louder than snare?

The snare is the foundation of the backbeat, and typically one of the loudest elements in the mix. Next, bring the kick fader up until it sounds almost as loud as the snare. It should be loud enough that the low frequencies are rich and powerful, but not so loud that it masks the bottom-end of the snare drum.

Should vocals be panned?

The best way to give your mix a solid core is to keep lower frequency sounds in the center. That means kicks, basses and anything else below the 120hz range. If your track has lead vocals pan them center as well. But as a general rule lead vocals should always be panned center.

Is a condenser mic better for vocals?

Condenser microphones are best used to capture vocals and high frequencies. They are also the preferred type of microphone for most studio applications. Because of the thin diaphragm and increased sensitivity, condenser mics are often used to pick up delicate sounds. They also need a power source.

What is a good EQ setting for vocals?

Best EQ Settings for Vocals

  • Roll off the low-end starting around 90 Hz.
  • Reduce the mud around 250 Hz.
  • Add a high shelf around 9 kHz & a high roll off around 18 kHz.
  • Add a presence boost around 5 kHz.
  • Boost the core around 1 kHz to 2 kHz.
  • Reduce sibilance around 5 kHz to 8 kHz.

Should I mix vocals in mono or stereo?

If you record one vocalist, your vocals should be mono. However, if you record two vocalists or more or if you record in a room with unique acoustics, the vocals should be stereo. Moreover, recording vocals in mono makes them sound powerful, clear, and upfront.

Leave a Reply

Your email address will not be published. Required fields are marked *