- 1 Why does my recording sound boxy?
- 2 How do you make your vocals sound smooth?
- 3 How do I get the best sound when recording vocals?
- 4 Why do my recorded vocals sound bad?
- 5 What does too much midrange sound like?
- 6 Should you EQ the master track?
- 7 How do you balance vocals in a mix?
- 8 Should vocals be louder than the beat?
- 9 How do you record vocals in your bedroom?
- 10 What level should I record vocals at?
- 11 How can I record good vocals at home?
- 12 Does my voice really sound like it does when recording?
- 13 Do singers hate their own voice?
- 14 Can you make bad vocals good?
Why does my recording sound boxy?
A boxy mix has too much mid-range frequency, typically between 250 Hz and 900 Hz or so—these frequencies typically contribute to a sound’s ‘body’—but too much will result in the mix as a whole sounding boxy. A hollow mix has too little midrange frequency content.
How do you make your vocals sound smooth?
Once you apply these ten techniques, your mixes as a whole will improve.
- Top-End Boost.
- Use a De’Esser.
- Remove Resonances.
- Control the Dynamics with Automation.
- Catch the Peaks with a Limiter.
- Use Multiband Compression.
- Enhance the Highs with Saturation.
- Use Delays Instead of Reverb.
How do I get the best sound when recording vocals?
Step-by-Step Vocal Recording Checklist
- Before the session, choose a room with very little reverb.
- Use some acoustic treatment.
- Set up your equipment.
- Get a rough headphone mix going.
- Position the singer 6 inches away from the microphone.
- Add a small amount of reverb to the vocal.
- Get the vocalist to warm up.
Why do my recorded vocals sound bad?
If your vocals are recorded in a bad room, it’s extremely obvious by the end of the mix. This is ESPECIALLY true for vocals. Room reflections can also cause compression and pitch correction to sound unnatural. It’ll make the vocals sound “fake,” like they were tacked on at the end of the mix.
What does too much midrange sound like?
Too much midrange energy in your mix can make it sound too hard, too boxy, too loud or too edgy. Too little can make it sound dull, scooped or soft.
Should you EQ the master track?
And Here’s How! Applying EQ to your master track can fix resonance issues, and help you to bring the most out of your tracks in the areas that matter. You can apply EQ in both the mixing and mastering stages in lots of different ways, and we’ll look at a few below.
How do you balance vocals in a mix?
Tip #1 – Here’s a top notch trick to get your vocals to sit on top of the mix nicely. Send everything but the vocals to their own aux, and apply a very subtle compressor (only a few dB’s reduction). Side chain the lead vocals to this compressor. This will dip the track by a 2 or 3 dB’s every time the vocals come in.
Should vocals be louder than the beat?
How loud should vocals be compared to instrumental. Vocals, especially the lead vocal should be louder than musical elements but a tad bit behind the drum transients in my opinion. But if you have an instrumental that has already been mastered and hyper-compressed which is often the case.
How do you record vocals in your bedroom?
The mic should be roughly in the center of the room. The closer you are to the walls, the more likely you are to capture reflections and unwanted low-end build up. Avoid corners at all costs. Make sure you set up a pop filter and, preferably, a portable vocal booth like the Reflexion Filter if you have one.
What level should I record vocals at?
You should record vocals at an average of -18dB for 24-bit resolution. The loudest parts of the recording should peak at -10dB and be lowest at -24dB. This is to keep an even balance on the level of the vocals without distortion.
How can I record good vocals at home?
7 Secrets for Getting Pro-Sounding Vocals on Home Recordings
- Get in the zone.
- Hack your bedroom.
- Position your mic and pop filter correctly.
- Get the right mic levels.
- Do several takes.
- Be careful with your vocal editing.
- Know when (and when not) to process your vocal sound.
Does my voice really sound like it does when recording?
When you hear your voice on a recording, you’re only hearing sounds transmitted via air conduction. This means that your voice usually sounds fuller and deeper to you than it really is. That’s why when you hear your voice on a recording, it usually sounds higher and weaker than you think it should.
Do singers hate their own voice?
Originally Answered: Is it normal as a singer to hate the sound of your voice on tape? Totally normal — and not just for singers, but most everyone. The first time someone hears her/his own voice on a recording, she/he is almost always shocked. Totally normal — and not just for singers, but most everyone.
Can you make bad vocals good?
Bringing in great singers to improve the sound of poor ones is an old studio trick and has worked to the benefit of more than a few ‘stars’. Just be careful not to take things too far and ditch your diva’s voice entirely when you’re mixing the vocals together.