Often asked: How Much Gain Reduction Rap Vocals?

How much should you compress vocals?

A good starting point for a rock vocal would be a 4:1 ratio with a medium-fast attack and a medium release. Then, set the threshold for around 4 to 6dB of gain reduction. Increase or decrease the attack time until you get the right level of forwardness for the mix.

What dB should rap vocals be at?

What dB should vocals be recorded at? You should record vocals at an average of -18dB for 24-bit resolution. The loudest parts of the recording should peak at -10dB and be lowest at -24dB. This is to keep an even balance on the level of the vocals without distortion.

What effects should I put on rap vocals?

The best vocal effects for rappers include de-essing, pitch shifting, time alignment, and parallel processing. Other great plugins that can help improve rap vocals include stutter and reverse effect, vocal delay throws, saturation, submixes, and distortion.

Should I compress vocals while recording?

So perhaps the best advice is to conservatively apply the best of both worlds: use a little compression while recording — just enough to help limit the most unruly peaks and phrases and to even out the recorded signal — and then add more compression to taste during mixing.

You might be interested:  Question: Why Do Prog Vocals Sound.So Similar?

Should you EQ or compress first?

Each position, EQ pre (before) or EQ post (after) compression produces a distinctly different sound, a different tonal quality, and coloration. As a rule, using EQ in front of your compressor produces a warmer, rounder tone, while using EQ after your compressor produces a cleaner, clearer sound.

Do rappers double their vocals?

Rappers and singers have traditionally recorded vocal doubles (informally called “vocal dubs”) on the ending phrases every bar or half a bar..

What dB level should I mix at?

I recommend mixing at -23 dB LUFS, or having your peaks be between -18dB and -3dB. This will allow the mastering engineer the opportunity to process your song, without having to resort to turning it down.

Should vocals be louder than kick?

Every vocal is different and every song is different as well. But generally speaking, lead vocal should be moderately loud or the loudest element next to your drums in your mix.

Where should vocals sit in a mix?

Tip #1 – Here’s a top notch trick to get your vocals to sit on top of the mix nicely. Send everything but the vocals to their own aux, and apply a very subtle compressor (only a few dB’s reduction). Side chain the lead vocals to this compressor. This will dip the track by a 2 or 3 dB’s every time the vocals come in.

Should rap vocals be dry?

Using Delay Over Reverb The best way to mix rap vocals is to keep them relatively dry. We’re talking about mixing rap vocals that are aggressive and upfront in the mix. Traditionally, engineers will opt for delay instead of reverb to keep that vocal forward and present — not washed away in a sea of reverb.

You might be interested:  Quick Answer: Vocals Low When Recording In Pro Tools?

How can I make my rap vocals stand out?

And with these four tips, you should be well on your way.

  1. Use compression when mixing vocals. As just mentioned, humans are anything but consistent.
  2. Get the EQ right. Of course, there’s much more to good sounding vocals than simply volume.
  3. Don’t leave them too dry.
  4. Always keep context in mind when mixing vocals.
  5. Conclusion.

How can I make my voice sound thicker?

Once you apply these ten techniques, your mixes as a whole will improve.

  1. Top-End Boost.
  2. Use a De’Esser.
  3. Remove Resonances.
  4. Control the Dynamics with Automation.
  5. Catch the Peaks with a Limiter.
  6. Use Multiband Compression.
  7. Enhance the Highs with Saturation.
  8. Use Delays Instead of Reverb.

Can you record with a compressor?

Recording Through Compressor Plugins Using UAD plugins and a Universal Audio interface, you can bake processing into your recordings on the way into your DAW, and direct monitor a vocal performance with compression applied in real-time—this means that using a hardware compressor isn’t your only option.

Should I record with a limiter?

Many recording at home will use a limiter purely to make their mixes louder, when all that really happens is you reduce your mix to a lifeless audio track with no dynamics. So while limiters are great in certain situations, be careful not to overuse them.

Leave a Reply

Your email address will not be published. Required fields are marked *