- 1 Can you Eq live vocals?
- 2 How do you master compress vocals?
- 3 How do you get the right volume when recording vocals?
- 4 Should you compress live vocals?
- 5 How do you set EQ for vocals?
- 6 What EQ frequency is vocals?
- 7 How loud should vocals be in a mix?
- 8 Should you compress or EQ first?
- 9 What DB should I record at?
- 10 How do you record vocals in your bedroom?
- 11 How loud should my microphone be?
- 12 How can I thicken my live vocals?
- 13 What is the best compressor for vocals?
Can you Eq live vocals?
To get the best results when equalizing live vocals, you must do six fundamental things: Start with flat EQs – Reset the EQ on the mixing console. Cut out the low-end rumble – Use the high-pass filter. Remove problematic (“hot”) frequencies – Add warmth to the sound.
How do you master compress vocals?
This is how to compress vocals using a lighter, more musical approach:
- First of all, load up a compressor.
- Next, lower the threshold and raise the ratio to extreme settings.
- Start with a medium attack time around 15ms and adjust to taste.
- Dial in a medium release time of 40ms and adjust from there.
How do you get the right volume when recording vocals?
Step-by-Step Vocal Recording Checklist
- Before the session, choose a room with very little reverb.
- Use some acoustic treatment.
- Set up your equipment.
- Get a rough headphone mix going.
- Position the singer 6 inches away from the microphone.
- Add a small amount of reverb to the vocal.
- Get the vocalist to warm up.
Should you compress live vocals?
Live sound is largely correcting problems with subtractive EQ. Sure, it’s fun to roll off some of the top-end on your hall reverb, but don’t let that distract you from the things that actually need attention. Compression should be used sparingly. The lead vocals should be the center of your attention.
How do you set EQ for vocals?
Best EQ Settings for Vocals
- Roll off the low-end starting around 90 Hz.
- Reduce the mud around 250 Hz.
- Add a high shelf around 9 kHz & a high roll off around 18 kHz.
- Add a presence boost around 5 kHz.
- Boost the core around 1 kHz to 2 kHz.
- Reduce sibilance around 5 kHz to 8 kHz.
What EQ frequency is vocals?
Male vocals will tend to have their fundamental frequencies between 100–300 Hz, while the fundamental frequencies of a female vocal will usually fall between 200–400 Hz.
How loud should vocals be in a mix?
Every vocal is different and every song is different as well. But generally speaking, lead vocal should be moderately loud or the loudest element next to your drums in your mix.
Should you compress or EQ first?
Each position, EQ pre (before) or EQ post (after) compression produces a distinctly different sound, a different tonal quality, and coloration. As a rule, using EQ in front of your compressor produces a warmer, rounder tone, while using EQ after your compressor produces a cleaner, clearer sound.
What DB should I record at?
You should record vocals at an average of -18dB for 24-bit resolution. The loudest parts of the recording should peak at -10dB and be lowest at -24dB. This is to keep an even balance on the level of the vocals without distortion. Why is decibel range so important when it comes to recording vocals?
How do you record vocals in your bedroom?
The mic should be roughly in the center of the room. The closer you are to the walls, the more likely you are to capture reflections and unwanted low-end build up. Avoid corners at all costs. Make sure you set up a pop filter and, preferably, a portable vocal booth like the Reflexion Filter if you have one.
How loud should my microphone be?
Levels on your recording device/computer sound editor gauge should jump between −12dB and −6dB, not exceeding −3dB and not going below −18dB when you speak or sing. That’s the universal rule. The final result allows both to amplify the soundtrack if needed or make it quieter without loosing anything critical.
How can I thicken my live vocals?
Use temporal, tuning, and low level compressing effects to create a vocal that sounds thick, and dense enough to cut through your mix. The idea is to create multiple reflections and voices, that can be combined with and augment the original signal.
What is the best compressor for vocals?
The Best Vocal Compressors for Studio-Quality Audio
- Avalon. VT-737SP. A go-to for professional pop, R&B, & rap studio recordings.
- Warm Audio. WA76. This limiting amplifier is designed to affordably emulate the classic UA 1176, which is nearly impossible to find these days.
- FMR Audio. Really Nice Compressor.