- 1 Is FL Studio good for vocals?
- 2 How do you EQ vocals like a pro?
- 3 Where should vocals sit in a mix?
- 4 Why do my vocals sound bad FL Studio?
- 5 Do professionals use FL Studio?
- 6 How do professionals mix their vocals?
- 7 What dB should my vocals be at?
- 8 Is a condenser mic better for vocals?
- 9 How loud should my vocals be in a mix?
- 10 How do you add warmth to vocals?
- 11 Should I normalize my vocals?
Is FL Studio good for vocals?
Is FL Studio Good for Recording Vocals? The short answer: Yes.
How do you EQ vocals like a pro?
Best EQ Settings for Vocals
- Roll off the low-end starting around 90 Hz.
- Reduce the mud around 250 Hz.
- Add a high shelf around 9 kHz & a high roll off around 18 kHz.
- Add a presence boost around 5 kHz.
- Boost the core around 1 kHz to 2 kHz.
- Reduce sibilance around 5 kHz to 8 kHz.
Where should vocals sit in a mix?
Tip #1 – Here’s a top notch trick to get your vocals to sit on top of the mix nicely. Send everything but the vocals to their own aux, and apply a very subtle compressor (only a few dB’s reduction). Side chain the lead vocals to this compressor. This will dip the track by a 2 or 3 dB’s every time the vocals come in.
Why do my vocals sound bad FL Studio?
Possibly too much use of gain to make up for poor signal strength. There are probanly other factors that all contribute to an underwhelming vocal sound. Are you using the microphone built into your mobile device or some other similar tiny electret condenser?
Do professionals use FL Studio?
FL Studio is one of the most popular music software programs used by professional and beginner music producers.
How do professionals mix their vocals?
10 Ways to Make Vocals Sound Modern & Professional
- Top-End Boost.
- Use a De’Esser.
- Remove Resonances.
- Control the Dynamics with Automation.
- Catch the Peaks with a Limiter.
- Use Multiband Compression.
- Enhance the Highs with Saturation.
- Use Delays Instead of Reverb.
What dB should my vocals be at?
What dB should vocals be recorded at? You should record vocals at an average of -18dB for 24-bit resolution. The loudest parts of the recording should peak at -10dB and be lowest at -24dB. This is to keep an even balance on the level of the vocals without distortion.
Is a condenser mic better for vocals?
Condenser microphones are best used to capture vocals and high frequencies. They are also the preferred type of microphone for most studio applications. Because of the thin diaphragm and increased sensitivity, condenser mics are often used to pick up delicate sounds. They also need a power source.
How loud should my vocals be in a mix?
Every vocal is different and every song is different as well. But generally speaking, lead vocal should be moderately loud or the loudest element next to your drums in your mix.
How do you add warmth to vocals?
Use Parallel Processing Instead of adding all the processing on the track itself, experiment with parallel processing. I like a good LA2A in parallel on vocals, sometimes with an analog-style EQ that’s boosted in the low-mids. Added underneath, it can give your vocals all the warmth you need.
Should I normalize my vocals?
It’s totally ok as long as it sounds good. You could normalize all tracks to (for example) -5, so you have a “peak-leveled” mix and start from there. Lower the volume of the beat before recording, like -10db. Then level your vocals around -18 db.