- 1 How do you make your singing voice fit?
- 2 Should vocals be higher than beat?
- 3 What frequency do vocals sit?
- 4 How many dB should vocals be in a mix?
- 5 Should I mix vocals with the beat?
- 6 Should vocals be in mono or stereo?
- 7 Should Kick be louder than snare?
- 8 How many dB should my beat be?
- 9 How do you make your vocals sound professional?
How do you make your singing voice fit?
9 Tips on How to Make Vocals Sit in The Mix
- Bring Up Fader. Why It Works – It brings up the vocal.
- Ride The Fader.
- Compress The Vocal.
- Compress The Mix.
- Limit The Mix.
- Boost Presence or Projection Frequencies.
- Boost Presence on Entire Mix.
- Reduce Reverb While Adding Delay.
Should vocals be higher than beat?
Should Vocals be Louder than the beat? No and Yes! Well it depends on the genre and style you are mixing or what the song calls for. What you don’t want is a vocal poking out like a sore thumb in your song.
What frequency do vocals sit?
Male vocals will tend to have their fundamental frequencies between 100–300 Hz, while the fundamental frequencies of a female vocal will usually fall between 200–400 Hz.
How many dB should vocals be in a mix?
If you mix them too loudly, they will stick out. What dB should vocals be recorded at? You should record vocals at an average of -18dB for 24-bit resolution. The loudest parts of the recording should peak at -10dB and be lowest at -24dB.
Should I mix vocals with the beat?
If you are just putting out a tape to grab exposure then placing vocals over a mastered beat is fine. If you’re planning to release a debut album then I would suggest mixing the beat with the vocals. You will be able to blend the vocals better with the instruments.
Should vocals be in mono or stereo?
Use the stereo field. The lead vocal should be in mono and central in the mix but the BVs can have as much width as you like. Keep it balanced, pan as many left as you do right.
Should Kick be louder than snare?
The snare is the foundation of the backbeat, and typically one of the loudest elements in the mix. Next, bring the kick fader up until it sounds almost as loud as the snare. It should be loud enough that the low frequencies are rich and powerful, but not so loud that it masks the bottom-end of the snare drum.
How many dB should my beat be?
I recommend mixing at -23 dB LUFS, or having your peaks be between -18dB and -3dB. This will allow the mastering engineer the opportunity to process your song, without having to resort to turning it down.
How do you make your vocals sound professional?
10 Ways to Make Vocals Sound Modern & Professional
- Top-End Boost.
- Use a De’Esser.
- Remove Resonances.
- Control the Dynamics with Automation.
- Catch the Peaks with a Limiter.
- Use Multiband Compression.
- Enhance the Highs with Saturation.
- Use Delays Instead of Reverb.