FAQ: Fl Studio How To Make A Beat To Vocals?

What dB should vocals be in a mix?

If you mix them too loudly, they will stick out. What dB should vocals be recorded at? You should record vocals at an average of -18dB for 24-bit resolution. The loudest parts of the recording should peak at -10dB and be lowest at -24dB.

How do you add vocals to a mastered beat?

How to Mix Vocals to an Already Mastered Instrumental

  1. Step 1: Reduce the Output Volume of the Mastered Instrumental.
  2. Step 2: Set the Input Gain at the Correct Level.
  3. Step 3: Apply Effects/FX.
  4. Step 4: Mix Your Project.
  5. Step 5: Create the Final Master.

Should vocals be louder than the beat?

How loud should vocals be compared to instrumental. Vocals, especially the lead vocal should be louder than musical elements but a tad bit behind the drum transients in my opinion. But if you have an instrumental that has already been mastered and hyper-compressed which is often the case.

Should I mix vocals with the beat?

If you are just putting out a tape to grab exposure then placing vocals over a mastered beat is fine. If you’re planning to release a debut album then I would suggest mixing the beat with the vocals. You will be able to blend the vocals better with the instruments.

You might be interested:  How To Remove Vocals On Audition?

How do you make a beat over a song?

Get To Work On Your First Beat

  1. Write your song. You can have your entire beat (or at least the basic structure) worked out before you even open your DAW software.
  2. Open your DAW.
  3. Set the tempo.
  4. Make the drum beat.
  5. Write the bass line.
  6. Add other virtual instruments.
  7. Add other samples or sound effects.

Where should vocals sit in a mix?

Tip #1 – Here’s a top notch trick to get your vocals to sit on top of the mix nicely. Send everything but the vocals to their own aux, and apply a very subtle compressor (only a few dB’s reduction). Side chain the lead vocals to this compressor. This will dip the track by a 2 or 3 dB’s every time the vocals come in.

What frequency do vocals sit?

Male vocals will tend to have their fundamental frequencies between 100–300 Hz, while the fundamental frequencies of a female vocal will usually fall between 200–400 Hz.

Leave a Reply

Your email address will not be published. Required fields are marked *